Gas Steam Fire Tube Boiler Dealer

Gas Steam Fire Tube Boiler Dealer

Startup steam fire tube boiler dealer steam temperature does not mention how high do? A: In the unit to start the process, often encounter steam pressure has reached the requirements, and the steam temperature was too much difference, especially in front of the turbine and the blast furnace or red switch occurs. Should take the following measures: appropriate to increase the amount of coal to improve the furnace heat load; adjust the secondary air ratio, increase the amount of lower secondary air; improve wind, air pressure, increased gas velocity; hydrophobic and full of air and exhaust mother pipe in front of the main steam isolation all hydrophobic.

Gas-fired steam steam fire tube boiler dealer is an advantage on the device using an environmentally friendly energy-saving: With the designers re-design of mechanical innovation, simple and easy to operate equipment, gas steam boiler is not only relatively simple, and better ensure the safe operation of ; saving advantages: high-temperature low-pressure gas steam boiler with a characteristic greatly reduces the stress levels of heating equipment, less direct advantage is the reduction in equipment investment. Electric heating boiler and the boiler is mainly composed of electric control box and control system. Its characteristics are environmentally friendly, clean, no pollution, no noise, automatic, with limited energy and reduce prices significantly, as a new boiler electric heating boiler equipment increasingly being recognized. Electric heating the core member is electrically heated boiler, directly determines the life of the boiler, to select a non-metallic electrical heating tube (such as a ceramic heating pipe), because it is resistant to the load, a long life, and a water separation structure, the boiler Wing no leakage. Fuel gas boiler is not only fuel but also refers to the gas boiler. Previously no such dual-fuel boiler, burner because either fuel or gas, no dual fuel burners. With the rapid development of the world energy equipment, some European countries begin production and sales of fuel gas burner, dual fuel burner and boiler combination of organic birth of a new breed of boiler - fuel gas-fired boiler. It was also said that the proportion of contact with air, just the right amount of fuel and the amount of combustion air composition in order to achieve combustion efficiency, but also reduce gas emissions and achieve energy-saving dual, very convenient. Gas steam boiler may be configured according to the actual amount of steam required, thus reducing waste of energy. The higher the degree of matching the actual demand and supply theory, better energy-saving effect. Continuous sewage heat can be utilized by a heat exchanger, thereby increasing the water temperature deoxygenated water. Gas-fired steam boilers and other machinery and equipment, more in line with current environmental requirements, so it has been widely used.

Comfortable life of people is inseparable from the northern winter heating steam fire tube boiler dealer, normal, stable heat source is vital to people's lives. But the attendant is an increasingly serious environmental pollution problems, the implementation of coal to gas policy without delay, using the gas hot water boiler is the general trend. In order to achieve green heating, the National Tourism Administration Service Center decided to phase out the existing coal-fired boilers, the introduction of clean and environmentally friendly gas hot water boiler. Fast boiler with their own strong comprehensive strength and rich experience in the heating industry cooperation gained the trust of the National Tourism Administration Service Center, and ultimately provide a vacuum hot water boiler (T6-2800 2 sets of 2.8MW by fast Boiler ).

What are the precautions in the loading and installation of gas-fired steam steam fire tube boiler dealers?

Gas-fired steam boilers are a very wide range of special equipments, widely used in food, chemical, paper, textile, construction and other industries. In the process of loading and installing a gas steam boiler, some problems must be paid attention, otherwise it may cause a certain degree of economic loss.

1. Pay attention to the following matters during the loading and unloading and handling of gas-fired boilers: the lifting capacity of the lifting equipment should match the weight of the lifting boiler. The lifting lug on the boiler with the lifting lugs that cannot be used for lifting can not be used for lifting. The length of the steel cord should be reasonably selected to avoid the scratching of the furnace due to the improper length of the steel cord. The boiler must be protected from any damage during handling and handling.

2. Reserves for maintenance space When installing boilers, ensure that there is sufficient maintenance space around the boiler.

3. Setting and precautions for the base and base of the gas steam boiler The boiler body must be installed on the basis of 100-150mm above the floor of the boiler room. It must be confirmed with the technical personnel of the boiler manufacturing company in advance and constructed according to the basic drawings. The anchor bolts must be reserved on the foundation. The foundation shall be capable of withstanding the maximum weight of the boiler and the amount of water it holds. When installing the base, you must first position it. After positioning, adjust to the same length of the two diagonals of the base, and then tighten all the fixing bolts. The installation of the base is carried out with reference to the reference line.

4, general precautions Be careful not to tilt and impact the boiler and accessories too much. No combustibles can be placed around the boiler. Do not use oil and water to smother the boiler. The boiler should normally be installed in a separate boiler room. The new gas-fired boiler room should not be connected to the house. The boiler room shall not be connected to Class A, Class B and Category C fire hazard rooms using flammable liquids. If connected to other production plants, the application firewall is separated.

5. The fire resistance grade and fire protection requirements of the boiler house building shall comply with the requirements of the Code for Fire Protection of Building Design and the Code for Fire Protection Design of High-rise Civil Buildings. The ground of the gas steam boiler room should be flat, non-flammable, no water accumulation, and the foundation load should meet the requirements. The power supply voltage of the gas steam boiler room should be stable to avoid causing the electrical components to burn out. If the voltage is unstable, it is recommended to install a voltage regulator. Ventilation equipment should be installed in the boiler room, and the boiler should be kept at room temperature below 50 °.

Free Chat

About Us

Contact Us