Vacuum phase change boilers in the industry are usually referred to as vacuum boilers. Professional vacuum boilers form a negative pressure vacuum environment within the enclosed furnace body. There is no danger of expansion and explosion because a vacuum boiler creates a low-pressure environment with little air, and then uses water to boil at a low temperature to produce steam. As a result, it is now commonly used in higher elevations. Let's find out what the features of the vacuum boiler are.
1, the vacuum boiler will not corrode because the internal structure of the vacuum boiler is negative pressure vacuum state, so it is completely isolated from the atmospheric pressure, so the pump pumps configured by the various units of the boiler will continuously discharge the steam from the unit. It does not corrode the internal structure, so vacuum phase change boilers perform fairly well in terms of durability.
2, safety and reliability are different from ordinary atmospheric pressure boilers. Because vacuum boilers pump air out of the inner container to form a vacuum environment, the furnace body does not work under the vacuum body in the course of use and will not be expanded by heat. It is not a pressure vessel, so there is no risk of explosion. At the same time, if the pressure increases due to faults or other perceived factors, the vacuum pressure switch automatically cuts off the power supply, so vacuum boilers are more reliable than other types of boilers in terms of safety.
Henan vacuum boiler in europe which method is well known that oxygen oxygen corrosion is a key issue and safe operation of the boiler service life of impact, and with the development of the hot water boiler corrosion problems more prominent, so welcomed by the people of Henan in order to ensure the safe operation of the boiler, oxygen is imperative to take effective measures for the excellent quality of Henan boiler, the boiler Henan oxygen and what method? First, the thermal oxygen Henan boiler heat deaerator, which is the principle of the boiler water is heated to saturation temperature for the corresponding pressure of the oxygen on the water oxygen evolution revisit excluded, so as to ensure the oxygen content of boiler water reaches Henan water quality standards, and Henan boiler thermal oxygen addition methods may not only oxygen, but also to remove carbon dioxide and other gases, users need not worry about this method of oxygen will increase the amount of dissolved salt content and other gases. Second, the vacuum deaerator Henan boiler vacuum deaerator is at less than atmospheric pressure, which also belongs to the low temperature oxygen scavenging. The quality of Henan boiler vacuum oxygen effect, the key is the ability to ensure the vacuum. Will be the same time as the heat load fluctuations, airtight coupled with the entire heating system is difficult to ensure, thus oxygen in the vacuum heating system is not particularly widespread application, the user should pay attention to the selection of such a measure oxygen. Third, the oxygen resolved resolved by strong oxygen binding deoxygenated water and oxygen gas, to achieve the purpose of oxygen Henan boiler, which boiler oxygen Henan method may be performed at room temperature, heating it need not , saves energy, while parsing Henan boiler operating costs than the previous two kinds of oxygen is much lower, but not remove other gases, it also reduces the pH value. Further reliable method of oxygen Henan integrity not only more than several boiler, there is another hydrazine, sodium sulfite and the like oxygen chemicals, resins, and greater investment and oxygen oxygen steel scraps smaller investment, short when the user takes oxygen method for Henan boiler, good to weigh the pros and cons of various methods of oxygen, combined with the economic and budgetary requirements, select the most appropriate, most oxygen methods.
During installation, the technical team fast vacuum boiler in europe plant according to the specific needs of our environment, our rational arrangement of stacks, pipes, and other auxiliary equipment, let us bring a lot of convenience in the latter part of the course. Fang fast responsible attitude also gives us impressed, sent a technical team for installation, commissioning and training to us, let us rest assured, peace of mind, peace of mind. --customer feedback
According to fuel classification, vacuum phase change boiler is the most important method at present, which is convenient for people to choose and buy. With the deepening of industrialization and the increase of people's demand, vacuum phase change boilers account for more and more shares in the market. The characteristics of different types of vacuum phase change boilers determine its most suitable position. Based on this situation, we should understand its classification and other characteristics in order to make the right choice. We will now tell you about the characteristics of different types of vacuum phase change boilers. Vacuum phase change boiler can also be called vacuum boiler, whose working principle is vacuum and phase change. According to the fuel, it can be divided. There are four categories, but three of them can be divided into one class, so the following two categories are divided into two categories, and the characteristics of each class are described.Free Chat
Copyright © 2020.Company name All rights reserved.