China Gas Hot Water Boiler Seller

China Gas Hot Water Boiler Seller

What problems should be paid attention to in maintenance Electric normal pressure Boiler

Nowadays, advanced electric atmospheric pressure boilers need to be used in industrial production as well as in daily life. However, the electric atmospheric pressure boiler is a highly operational mechatronics equipment, such as customer inspection, maintenance is not timely will result in equipment line aging, equipment oil circuit and oil pump wear and so on. Therefore, users need to pay attention to the maintenance of equipment when running boilers, then, what problems should users pay attention to in the maintenance of electric pressure boilers with good performance?

1, pay attention to stop furnace detection electric atmospheric pressure boiler in the maintenance, users should let the equipment according to the normal shutdown procedure operation to achieve slow cooling, at the same time, Users should use pot water circulation and furnace ventilation to gradually reduce the temperature in the pot and furnace. It is worth noting that when opening the door hole of the equipment, users need to pay attention to preventing the burning of steam, hot water and flue gas in the boiler.

2, note that when users maintain the insulation, the combustor and flue of the detected atmospheric pressure boiler should be separated from the total flue or the other running boiler flue. The test results are as follows: (1) the combustor and flue of the tested atmospheric pressure boiler should be separated from the main flue or other running boiler. And the flue gate should be closed tightly, and in the partition after ventilation. In addition, the blind plate used in equipment partition should have sufficient strength and hardness to avoid being bulged by high pressure medium in the operation of electric normal pressure boiler, and the partition position should be clearly indicated to avoid confusion.

3, note that the user must completely cut off the connection pipe between the vessel and the gas equipment, especially to the combustible and toxic medium equipment before the inspection of the atmospheric pressure vessel is carried out by the user of the equipment container. In addition, the equipment container not only needs to close the equipment valve, but also needs to use the blind plate of the equipment to close the valve so as to prevent the gas leakage into the container and cause the fire explosion or poisoning accident of the valve so as to cause the combustible or toxic gas to leak into the container.

It is reported that the atmosphere and do in Hebei Province recently issued issued a "coal-fired boiler upgrade Hebei three-year battle plan" (hereinafter referred to as "Plan"). "Plan" put forward, will continue to increase efforts to eliminate 35 tons of steam / hour and coal-fired boilers, as of 2020, the province's 35 steam tons / hour and the boiler "No Coal", while steaming retains 35 t / h coal-fired boiler and above the implementation of energy efficiency retrofits to mention environmental protection.

2017, Hebei cities (including Dingzhou, Xinji) built-up area for 35 steam tons / hour and coal-fired boilers, the county seat 10 steam tons / hour and coal-fired boilers basically completed "clear" work. 2018, the province plans to phase out a total of 6764 units 13466 tons of steam coal-fired boiler, stove and stove operating a small coal stove, have been eliminated as of September 35 steam tons / hour and coal-fired boilers 6141 Taiwan 12485 tons of steam.

Next, Hebei will focus on the implementation of nine key tasks:

First, actively promote central heating facilities, industrial parks and accelerate the elimination of coal-fired heating boilers, the implementation of "the big-generation small" and "a garden a furnace" governance program, organized industrial wasteheat special action.

Second, increase clean energy alternatives, optimize energy structure boiler. As of 2020, municipalities and districts and counties built-up area of ​​straight pipe central heating and clean energy heating rate of 100%.

Third, increase the coal-fired boiler energy conservation and environmental protection to enhance the transformation efforts.

Fourth, increased pollutant emissions and coal quality management and control efforts, deepening the boiler control. For reservations of 35 steam tons / hour or more coal-fired boiler to install air pollution automatic monitoring facilities and networking with the provincial and municipal environmental protection department.

Fifth, to accelerate the application of new energy technologies, promote demonstration projects mature. Require municipalities to develop clean energy development plan, and carry out the heating boiler can too + + PV, geothermal pilot, accelerating wind power demonstration heating Zhangjiakou region, to promote biomass energy, gas, alcohol-based fuel, industrial waste heat, light hydrocarbon fuel and other types of energy.

Sixth, give prominence to coal-fired boilers "Gas", "electricity" management. Municipalities To plan, implementation of the "gas will change," "power given to change." Heating boilers complete transformation of all time ahead of the end of August, without access to gas, clean energy power light before shifting coal-fired heating boilers can not be removed.

Seven, to carry out comprehensive environmental remediation coal-fired boilers, the implementation of grid management systems.

Eight new boiler strict access, strict implementation of pollutants and reduce the amount of times the coal alternative system. By the end of 2018, the province's coal-fired boiler control in less than 110,000 tons of steam.

Nine, strict boiler exclusion criteria, norms and acceptance transformation.

At present several common boiler energy-saving technologies: usually for boiler manufacturers, it means that you are saving boiler to maximize the interests of customers, providing customers with unlimited fuel savings, the electricity consumption, water consumption and so on. But the wide range of energy-saving, does not refer to an aspect of optimization can save energy boilers, here's a look now common boiler energy-saving technologies: 1 furnace arch. Industrial boiler furnace arch is very important. Arch role is to cause the furnace hearth and the organization of the mixed gas and the radiation hot flue gas flow, ignition and combustion of the fuel in a timely manner. At present, the actual amount of industrial steam boiler with its rated load often do not match, the use of coal varies widely, but often with the design coal are quite different, so in actual use, often as necessary for the furnace arch modified to meet the needs of coals. Heteroaryl coal used by the inferior design coal, the boiler furnace exit gas temperature occurs is low (about 700 degrees), lower than 200 degrees design.

9 major technical characteristics of the gas china hot water boiler seller you know? 1, according to atmospheric boiler design, boiler in a non-pressure state, there is no safety hazard. 2, the use of advanced multi-layer insulation centrifugal glass wool, steel for packaging famous white color, heat loss, anti-rust appearance 3, burner configuration imported brands, high degree of automation, automatic purge controller according to the instruction, the electronic auto-ignition, automatic combustion (gas) automatically adjusting the ratio of wind oil, security and stability performance, good combustion. And there are flameout protection device, ensure safe operation. 4, the computer controller hot water boiler, all the functions are stored on a magic smart chip, a key to power boilers, automatic timing, temperature operation, the user can set the start, shutdown time, after setting, without special duty, save time, and effort. 5, the inner fire tube inserted spoiler retardant, smoke slow speed, to strengthen the heat exchanger, the temperature of the flue gas discharged from a low smoke chamber, reducing heat loss and save fuel. 6, large font display temperature, easy to grasp and boiler operating conditions of the system, the water temperature can be freely set from 10 ℃ to 90 ℃, automatic boiler or heating system to provide users with life, bath with hot water. 7, the control system in accordance with the temperature control of boiler water circulation pump start and stop, boiler water circulating pump starts when the water reaches an upper limit temperature, lower than the hot water circulation pump stops when the water temperature lower limit. 8, horizontal fuel gas hot water boiler three return all wet back structure, using a large furnace, rough smoke tube design, increased furnace radiation heat absorption, the effective energy saving. Using threaded pipe and waveform furnace, greatly enhanced heat transfer effect, greatly saving fuel consumption. 9, while the machine is equipped with thermal protection (ultrahigh temperature furnace, the burner is automatically stopped and an alarm buzzer, the second over protection (the boiler shell temperature exceeds 105 deg.] C, the secondary circuit is automatically cut off), the lack of anti-dry protection of water (when water is lower than the low water level of the furnace, the boiler is stopped and an alarm beep), a boiler leakage protection (the control system detects electrical leakage, short circuit, automatically cut off the power).

Free Chat

About Us

Contact Us