Vertical Gas Oil Steam Boiler

Vertical Gas Oil Steam Boiler

Fuel gas control step and the blowing process air volume of the total fuel gas vertical oil steam boiler steam boiler is achieved by adjusting a liquid coupling scoop blower. Organization fuel gas steam boiler combustion, is to make a, air pressure, air flow of secondary air with the good. Adjusting the amount of primary air should meet it carries the fuel into the furnace ignition of volatile oxygen required, and to maintain a certain speed, and without clogging the fuel discharge pipe of the jet having a certain rigidity. Primary air volume is too large and too small, the wind speed is too high and too low, should be avoided. In addition to adjusting the secondary air of combustion of the fuel should ensure that the oxygen demand, but must maintain a certain wind speed and primary air is mixed with the master time should have a strong stirring and mixing coke penetrate "the Gray" kinetic , which requires the case may be, each layer of the secondary air flow rate, in order to achieve stable combustion and flue gas excess oxygen appropriate destination. Fuel gas steam boiler, secondary air with what is better? Primary air volume air volume of the total share is called the primary air rate. A small air fraction, pulverized coal is heated to at least the heat required for the ignition point, fire faster, but the amount of primary air to satisfy the principle of combustion of volatiles. Secondary air mixed with the primary air time to the right. If it is mixed before ignition, means an increase in the amount of primary air, so that the ignition delay; hypoxia combustion secondary air if mixed will make late after ignition; if secondary air is mixed all at one position, since the secondary air temperature well below flame temperature, the flame temperature decreases, the combustion slows down, causing the fire. Therefore, the secondary air mixed with fuel should be based on the nature of the combustion zone as required timely sent, so that the combustion of oxygen, and will not reduce the flame temperature to ensure complete combustion and ignition stability. One or two wind speed with what is better? Fuel gas steam boiler once the wind speed is high, the fuel gas stream will catch fire in places far away from the burner, the ignition point postponed; once the wind speed is too low, it will cause a blocked ducts, and ignition point is too far forward, the burner will burn , but also easy to coke near the burner.

In early 2019, Xingtai City, Hebei Province, air pollution control for industrial enterprises, to develop the relevant regulations. Mainly for the protection and improvement of the atmospheric environment, prevention of air pollution and protect public health, promote the construction of ecological civilization, and promote the development of sustainable economic and social development goals.

First, according to the national industrial policy, Hebei Province, strict control of new construction, renovation, expansion of iron and steel, cement, plate glass, synthetic chemical pharmaceuticals, non-ferrous metal smelting, building ceramics, chemicals and other industrial projects.

Iron and steel, cement, plate glass, synthetic chemical pharmaceuticals, non-ferrous metal smelting, building ceramics, chemicals and other key industries cleaner production audits in accordance with law, the use of advanced clean production technologies, processes and equipment.

Urban area, high above emissions in key industries around the ecological red line in the control area, high-pollution projects should be gradual relocation, renovation or restructuring, exit.

Air pollution insurance companies encourage heavy environmental pollution liability insurance.

Second, the city and county (city, district) people's government may take their overall economic efficiency sorting, etc., specific measures for serious overcapacity in the industry, the atmosphere of heavily polluting enterprises, the differential credit, the difference is the price of water, different gas prices, punitive tariffs, etc. .

Third, the industrial concentration area should develop cogeneration and district heating, heat unified solution. In addition to centralized district heating and combined heat and power, waste incineration and biomass power generation project, the city's ban on new or expanded high-polluting fuel for power plants, ban high-pollution fuel combustion zone ban on new construction, expansion-owned high-polluting fuel boiler heat supporting units supply station.

Boiler for industrial production should reach atmospheric pollutant emission standards set by the State and the boiler Hebei and marked fuel requirements and atmospheric pollutant emission control targets.

Fourth, industrial enterprises store coal, cement, lime, sand and other materials easy to produce pollution should take sealed enclosure, cover, cleaning, watering and other measures to prevent dust pollution.

Fifth, iron and steel, petroleum, nonferrous metals, electric power, coke, construction materials, metallurgy, chemical and other industrial enterprises in the production process emissions of dust, nitrogen oxides and sulfides, shall adopt cleaner production processes, supporting the construction dust removal, desulfurization, denitration apparatus, or take other measures to control the emission of air pollutants like transformation.

Operation of the boiler, including what? Including the operation of the boiler, what does? Following on from the Henan fast boiler company to tell you about: 1. The water level regulation of normal water level in the middle of the gauge (1) of the boiler. Operation with the magnitude of the load is adjusted: to maintain a high level during low load, high load to maintain a low level. Changes should not be down more than 40 mm. (2) to be run on the water level gauge to compare the two groups, if the water level display should be corrected promptly identify the cause. (3) To achieve a balanced continuous boiler feed water, ground water supply, water supply less, to maintain the water level in the normal water level fluctuates slightly in the vicinity. (4) load change is large, prone to false level. Pay attention to judgment, in order to avoid misuse. 2. Steam pressure regulator (1) when the boiler must constantly monitor the pressure gauge indicated. To maintain stable steam pressure, boiler pressure must not exceed the design pressure. (2) increasing the boiler load: Steam pressure decreased boiler load is increased, if the level is high at this time, the amount of water should be reduced to a water supply or suspend, the amount of coal and increase the air volume. Gradually increase the amount of water at the same time to strengthen the burning, keep the steam pressure and the water level is normal. (3) boiler load reduction: the vapor pressure rises to reduce boiler load, if the level is high at this time, the amount of coal should be reduced and the air volume, reduced combustion. Then the appropriate water reduction or suspension of water supply to the water vapor pressure and stability in the nominal range. Then press the normal combustion and to adjust the amount of water. If the actual water level within the boiler is low, to increase the amount of water should, until the water level returns to normal after the combustion and needs to be adjusted according to the water vapor pressure and load changes. 3. Combustion adjustment (1) combustion index. Normal combustion boiler comprises a uniform supply of the fuel, reasonable ventilation, adjusting three basic aspects combustion. B. maintain a high temperature of the combustion chamber temperature of the upper layer is preferably in the 1100-1300 ℃, flame orange in color. Flame reddish color indicates that the amount is not enough to the wind, the color white indicates that excessive wind. It should be appropriately adjusted. C. fuel ash to reduce ash content in the combustibles to be below 10%. d. reducing the temperature of the exhaust gas boiler exhaust gas temperature should be controlled below 200 ℃. e. excess air negative pressure holding furnace boiler 1.2-1.4, by adjusting the balance of the blowers to maintain the furnace pressure is 2-3mm. F. to improve the thermal efficiency of the boiler thermal efficiency of the boiler should be kept above 60%. (2) adjusting the combustion a. Reasonable amount and the distribution of fuel to the amount of air needed for combustion. Ventilation should first increase the amount of fuel increases, it should first reduce the amount of fuel supply reduced ventilation. b wind principle feature: burn promoting intermediate ends. That is, after the coal into the coal starts to warm up the shutter, fire line front arch, the primary combustion zone, the middle grate to burn the rear grate zone. c is the normal combustion conditions: fuel ignition start at 300mm from the shutter of coal, even flames, the fire bed formation, at the end away from the combustion grate at the end of 300-500mm. d. Hold appropriate furnace temperature to avoid coking. E. fire bed to maintain the homogeneous combustion, to avoid burning fire bed obliquely. F. less than 30 minutes residence time of the fuel on the grate. Our company provides services related to the installation of the boiler!

The main difference between the gas boiler and gas vertical oil steam boiler What is the main difference between what gas boilers and gas steam boiler is? Nominally, a clear distinction between gas and steam boiler wherein the boiler fuel gas is different. The former use of natural gas, which uses coal. I think a lot of user concerns boiler is why they should cancel gas-fired boiler, because many people have purchased and used the gas boiler. If they switch to gas-fired boiler, it will be a huge expenditure. First, according to the current direction of development of the ecological environment of China, gas boilers will gradually be replaced by gas-fired boiler or other clean and green energy boilers, gradually withdraw from the stage of history. To say a big difference between the gas boiler and gas steam boilers, gas-fired boiler is mainly due to the elimination of environmental protection. From the fuel supply portion, only a gas boiler tube connected to the boiler; gas boiler needs coal field, coal (with or artificial), coal transportation, handling, storage and loading of coal boiler process. It will produce dust, causing serious pollution to the people's living environment. From the point of view of atmospheric emissions, natural gas is very small dust content, substantially negligible; high ash content of coal, the ash content of about 10-30%, the combustion smoke. If dust emission reduction facilities, emissions will increase; if more dust removal facilities, the corresponding costs will increase, this is not a long-term solution. In addition, the sulfur content of natural gas is very small, dust removal, desulfurization and denitrification can get gas boilers, gas boilers need only consider the denitrification problem. From the other point of view of waste disposal, natural gas substantially free of other contaminants, especially in city gas. In the case of coal, the coal field (especially small boilers mainly built in the open air) to produce coal slurry water during the rainy season, or sink into groundwater. When entering the surface water, the combustion ash conveyance of dust is generated. Of course, there are differences also in other ways. For small boilers, gas boilers are more energy efficient than gas boilers, equipment flow is simple, small footprint, low operating and maintenance costs, and so on. These are the main difference between the gas boiler and gas steam boilers, as well as the significance out of gas boiler. As can be seen, the use of gas-fired boiler is the trend of the whole society.

Free Chat

About Us

Contact Us